properties

• Easily network-enable virtually any serial device
  
• Flexible, well-developed IP protocol stack
  
• Ethernet RJ45 (10BASE-T) connector on the board
  
• TTL serial interface
  
• Two serial ports
  
• Accepts 5VDC regulated input power
  
• HTTP, Serial, Telnet and SNMP management
  
• Flash ROM for easy software upgrades
  
• Custom protocol support available

description

With the measurements of 49.15 x 40 mm only, the LANTRONIX Micro can easily fit into almost any size device that would benefit from integrated network connectivity.
Serial interfacing is accomplished via a TTL connector and for Ethernet access, an RJ45 (10BASE-T) is available. The CoBox Micro supports the same IP protocol stack found on the other LANTRONIX CoBox products.

further informations

Ordering Information:

CO-E1-00AAR     Micro with no RJ45 and LEDS, RoHS 
CO-E1-11AAR     Micro Device Server, Ethernet, RoHS
CO-E1-IAP-R       Micro Industrial Protocol, RoHS
CO-E1M-00AAR  Micro with no RJ45 and LEDS, with MODBUS Firmware, RoHS
CO-E1M-11AAR  Micro with MODBUS Firmware, RoHS
CO-E2-00AB-R   Micro Generic, 2 Serial Port support with no RJ45 and LEDS, RoHS
CO-E2-113AAR  Micro, 2 Serial Port support and TTL Header on back of board, RoHS
CO-E2-11AAR    Micro with 2 Serial Port support, RoHS
CO-E2-12AA-R   Micro with no LEDS, but instead, Header Pins on the TTL side, RoHS
CO-E2-21ABR    Micro, Pin Header on TTL side instead of RJ45, RoHS
CO-E2-22AAR    Micro with 2 TTL Channels, RoHS 
CO-E2-22AB-R  Micro with 2TTL Channel, RoHS
CO-E2-IAPR       Micro 2 Channel IAP, RoHS